Installation - ETNA T3400 Notice D'utilisation

Removing and refitting the oven
door
Removing the oven door
- Open the oven door as far as it will go.
- Insert the locking pins enclosed into the drilled
holes of the door hinges.
- Grasp the oven door at both sides and lift it up
until it is nearly closed.
- Gently lift the door and pull the hinges forward
away from the door opening.
Important! Risk of injury!
Do not pull the locking pins out of the drilled
holes. The hinge is under tension. It must also be
under tension on installation. Once the pins
have been removed it is no longer possible to
tension and secure the hinge.
Refitting the oven door
- Grasp the oven door at both sides and slide
the hinges into the openings on the oven. The
hinge will click into place.
- Slowly open the oven door until it is fully open.
- Remove the locking pins from the drilled holes
of the door hinges again.
- Close the oven door.
Installation of oven
Having connected the oven to the mains supply,
carry out the following steps:
Place the oven in the cabinet.
n
Ensure that the mains cable is neither
n
obstructed nor is resting on the top surface of
the oven.
Fix the oven to the cabinet with the 4 screws
n
supplied.
Check that the oven casing is not in contact
n
with the walls of the cabinet and that there is
a gap between them of at least 2 mm.
min. 40