ARTHUR MARTIN AW6F4742AB Notice D'utilisation page 7

2. The inlet hose
CAUTION! Make sure there is
no damage to hoses and there
are no leaks from the
couplings. Do not use an
extension hose if the inlet hose
is too short. Contact the service
centre for a replacement inlet
hose.
1. Connect the water inlet hose to the
back of the appliance.
2. Position it toward left or right depending
on the positon of the water tap. Make sure
that the inlet hose is not in vertical
position.
3. If necessary, loosen the ring nut to set it
in the correct position.
4. Connect the water inlet hose to the cold
water tap with 3/4'' thread.
3. Water drainage
The drain hose should stay at a height of
no less than 60 cm and not more than 100
cm.
You can extend the drain hose
to maximum 400 cm. Contact
the authorised service centre
for the other drain hose and the
extension.
It is possible to connect the drain hose in
different ways:
O O
45 45
O O
20 20
1. Make a U shape with the drain hose
and put it around the plastic hose guide.
2. On the edge of a sink - Fasten the
guide to the water tap or to the wall.
Make sure that the plastic
guide cannot move when the
appliance drains and the drain
hose end is not immersed in
the water. There may be a
return of dirty water into the
appliance.
3. If the end of the drain hose looks like
this (see the picture), you can push it
directly into the stand pipe.
4. To a stand pipe with vent-hole - Insert
the drain hose directly into a drain pipe.
7