EUROM Electric Weedburner 2 in 1 Mode D'emploi page 29

these instructions use it. Electrical devices are dangerous in the
hands of inexperienced users.
 Make sure your electrical devices are well maintained. Check to
ensure that the device is assembled correctly. Check whether any
parts are defective or for other elements that could impact upon the
functioning of the device. Have any damaged devices repaired before
use. Many accidents are caused by badly maintained devices.
 Use all electrical devices and accessories as given in the instructions
and for the intended purpose(s). Be aware of the working conditions
and the task to be completed. Using electrical devices for tasks for
which they are not intended could lead to hazardous situations.
 Contact a qualified specialist who uses original parts if the device
needs to be repaired. This will ensure the device works effectively.
Special safety instructions for electrical devices
When using electrical devices, the safety instructions must be applied at all time
to prevent shocks, injury and/or fire risks. Read and apply the advice before you
use the machinery.
When using the device
 Check the following:
- Does the power supply for the device correspond with the mains supply of 230-240
Volt?
- Are the mains cable and plug in good condition: sturdy, without loose ends or
damage.
 Be careful when using extension cables.
 Do not use the device in damp conditions.
 The metal mouthpiece will get hot. Be careful with it and do not touch the metal component!
 Prevent damage to the heating element. Do not close off the mouthpiece and the ventilation
openings and/or block them.
 Stay with the device if it is switched on.
 Never direct the flow of heat towards persons and/or animals.
 Do not look into the mouthpiece/burner opening.
 Do not use the device in rainy weather or a damp environment or in an environment where
there is the risk of an explosion, or near to flammable liquids.
 Do not use the device in dry areas, to avoid the risk of fire.
 During breaks, move all components from the device, e.g. when replacing the mouthpiece,
and remove the plug from the socket when not in use.
 Do not point the device at the same location for a long period during use.
 Do not place the mouthpiece opening too close to the surface. A buildup of air could lead to
the device overheating.
 Be aware of the immediate working environment and the surrounding area. The heat can
penetrate flammable materials that are outside the immediate vicinity.
 The device must be kept clean, dry and free of oil or lubrication grease.
 Never use the device for inappropriate purposes.
 Never run when holding the device.
 Always lead the mains cable to the rear, away from the device. So that the cable and/or any
extension cable does not come into contact with the hot components on the weed burner.
29