Correct Use; Modifications To The Product; Warnings; Safety Notes - oventrop Unibox TQ RTL Notice D'utilisation

Safety-related information
• DIN EN 16313

2.2 Correct use

Operating safety is only guaranteed if the prod-
uct is used correctly.
The "Unibox TQ RTL" limits the fluid tempera-
ture of a radiator heating circuit and uses it to
ensure the temperature balance of floor and
wall surfaces in individual rooms. Moreover, the
"Unibox TQ RTL" is used for individual room
temperature control. The flow rate is automat-
ically controlled by the integrated "QA" valve
insert.
Any other use of the product will be considered
incorrect use.
Claims of any kind against the manufacturer
and/or its authorised representatives due to
damage caused by incorrect use will not be
accepted.
Observance of the operating instructions is part
of compliance with correct use.

2.3 Modifications to the product

Modifications to the product are not permitted.
In the case of modifications to the product, the
warranty will become void. The manufacturer
will not accept liability for damage and break-
downs caused by modifications to the product.

2.4 Warnings

Each warning contains the following elements:
Warning symbol SIGNAL WORD
Type and source of danger!
Possible consequences if the danger oc-
curs or the warning is ignored.
f Ways to avoid the danger.
Signal words identify the severity of the danger
arising from a situation.
26
NOTICE
Indicates a situation that may lead to
damage to property if not avoided.

2.5 Safety notes

The product is manufactured in accordance
with the latest technical standards and is safe
to use. However, residual dangers to people
and property may occur during installation and
operation.
2.5.1 Danger caused by inadequately
qualified personnel
Work on this product may only be carried out
by appropriately qualified installers.
Sanitary, heating and air-conditioning
specialists
Sanitary, heating and air-conditioning spe-
cialists are able to carry out work on heat-
ing and cooling systems as well as potable
water systems as a result of their professional
training, expertise and experience, as well as
their knowledge of the relevant standards and
regulations. They must be able to independent-
ly identify possible dangers.
2.5.2 Risk of injury in case of improper
work
Angular components, protrusions and edges
both inside and outside the product may cause
injuries.
f Before starting work, make sure that there
is sufficient space.
f Handle open and sharp-edged compo-
nents with care.
f Make sure that the workplace is tidy and
clean to avoid accidents.
2.5.3 Danger caused by an
uncontrolled escape of hot fluids
f Only carry out work when the product is
depressurised.
f Allow the product to cool down before
working on it.
f Check that the product is not leaking after
Unibox TQ RTL
102273980-V01.06.2019