Toto TBMV Manuel D'installation Et D'utilisation page 4

INSTALLATION PROCEDURE - DIVERTER
1. Thread on mounting nut to the
bottom of the diverter body.
Place washer and gasket as
shown.
Valve Assembly (2)
2. Pass the diverter body up through
the installation hole.
Place (smaller) gasket and fasten
collar to diverter body until it stops.
3. Fixate the diverter by threading the
mounting nut up the diverter until
hand tight. Tighten the retaining
screws equally to secure.
Do not overtighten!
INSTALLATION PROCEDURE - VALVES
1. Thread on mounting nut to the bottom
of the valve body. Place washer and
gasket as shown.
Valve Assembly (2)
Mounting
Collar
Gasket
Diverter Assembly*
Gasket
(Rubber)
Washer
(Metal)
Nut
Diverter Assembly*
Mounting
Nut
4
Ha
Gasket
(Rubber)
Washer
(Metal)
Mounting
Nut
Ha
Collar
Gasket
Gasket
(Rubber)
Washer
(Metal)
Mounting
Nut