Makita DHP446 Manuel D'instructions page 5

ENGLISH (Original instructions)
1. Red indicator
2. Button
3. Battery cartridge
4. Star marking
5. Switch trigger
6. Lamp
7. Reversing switch lever
8. Speed change lever
9. Action mode changing ring
SPECIFICATIONS
Model
Capacities
-1
No load speed (min )
Blows per minute
Overall length
Net weight
Standard battery cartridge
Rated voltage
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications and battery cartridge may differ from country to country.
• Weight, with battery cartridge, according to EPTA-Procedure 01/2003
Intended use
The tool is intended for impact drilling in brick, concrete
and stone as well as for drilling without impact in wood,
metal, ceramic and plastic.
General Power Tool Safety
Warnings
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and
instructions for future reference.
CORDLESS HAMMER DRIVER
DRILL SAFETY WARNINGS
1. Wear ear protectors when impact drilling.
Exposure to noise can cause hearing loss.
Explanation of general view
10. Adjusting ring
11. Graduation
12. Arrow
13. Sleeve
14. Groove
15. Hook
16. Screw
17. Bit holder
18. Bit
Concrete
Steel
Wood
Wood screw
Machine screw
High (2)
Low (1)
High (2)
Low (1)
ENE039-1
GEA010-1
GEB056-5
DHP446
6 mm x 75 mm
1.4 kg 1.7 kg
BL1430/
BL1415N
BL1440
D.C. 14.4 V
2. Use auxiliary handle(s), if supplied with the tool.
Loss of control can cause personal injury.
3. Hold power tool by insulated gripping surfaces,
when performing an operation where the cutting
accessory may contact hidden wiring. Cutting
accessory contacting a "live" wire may make exposed
metal parts of the power tool "live" and could give the
operator an electric shock.
4. Hold power tool by insulated gripping surfaces,
when performing an operation where the fastener
may contact hidden wiring. Fasteners contacting a
"live" wire may make exposed metal parts of the
power tool "live" and could give the operator an
electric shock.
5. Always be sure you have a firm footing.
Be sure no one is below when using the tool in
high locations.
6. Hold the tool firmly.
7. Keep hands away from rotating parts.
8. Do not leave the tool running. Operate the tool
only when hand-held.
19. Blow-out bulb
20. Limit mark
21. Rear cover
22. Recessed part
23. Spring
24. Arm
25. Carbon brush cap
26. Hole
DHP456
13 mm
13 mm
38 mm
10 mm x 89 mm
M6
0 - 1,500
0 - 400
0 - 22,500
0 - 6,000
206 mm
1.6 kg
BL1815/
BL1815N/
BL1820
D.C. 18 V
1.8 kg
BL1830/
BL1840/
BL1850
5