Nordpeis Lugano Manuel D'installation page 5

Lugano
Insert
N-27
Steel chimney
Can be installed with steel chimney.
Weight including insert
Illustration (FIG 1)
*The illustration indicates the approximate centre height
of the hole for the flue. As the flue is inclining, this
height will vary depending on where the surround is
installed. Distortions in floors and walls may influence
the height. Dry stack the fireplace for accurate height
and positioning of the flue/chimney connection. If
a fresh air supply set (accessory) is connected through
the floor, mark where the hole should be.
Safety Distances (FIG 2)
Ensure that the safety distances are complied with.
Please note that these safety distances can vary from
country to country.
The distance from the glass in the door to a lateral wall
must be of at least 600 mm.
The distance between the top of the convection air
outlet and roof of inflammable material must be at least
550 mm.
The distance to any inflammable material in front of the
opening of the insert must be of at least 1,5 m.
Assembly instructions (FIG 3 - FIG 13)
FIG 3: Place the steel plate under the insert and then
assemble the lateral heat shields. Adjust the legs of
the insert to the appropriate height and ensure that the
insert is levelled.
475 kg
FIG 4: Position the element 3 WITHOUT GLUE (ensure
to hold the element in place) in order to adjust more
accurately the height of the insert and place the log
storage unit (part 4 and 5). Ensure that there is a gap
between the insert and the surround as the insert
expand with heat. Read the text on Adjustment for more
information.
FIG 5 / FIG 6: Mount the log storage unit (part 4 and 5).
Adjust the distance to the element 3.
FIG 7: Remove element 3.
FIG 9: Mount element 7, this section will lock the lateral
elements together.
FIG 10: Mount element 3 (8), now with glue.
FIG 11: Ensure that there is a gap between the insert
and the surround as the insert expand with heat. Read
the text on Adjustment for more information.
FIG 12: Place the top grid (10) and mount the lateral
grid (11) with the two screws that are included.
FIG Z: Once the fireplace is assembled, fill the joints
with acrylic and even them out with a sponge or
finger and some soapy water, in order to have a clear
indentation between the elements.
GB
5