Bresser TemeoTrend SQ Mode D'emploi page 21

RESET button (Fig. 2, 13/ Fig. 3, 18)
Press the button with a thin metal rod in the
event of a malfunction for resetting the device
settings.
Wall mounting assembly
(Fig. 2, 11/ Fig. 3, 17)
For mounting of the sensor to a suitable wall
hook.
Settings and displays
Automatic setting of the time and date.
Display of the signal strength
The signal strength indication is organized into
4 levels. If the symbol
signal is received. The strength of the received
signal can be subdivided into 4 categories:
No signal
Weak signal
Adequate signal
Good signal
flashes, the time
If the time signal is received successfully,
the time synchronization symbol appears
permanently on the display
Otherwise, the symbol is no longer displayed.
Pay attention: By pressing the RCC button (Fig.
1, 8) you can also start the synchronization of
the time signal manually. This reception mode
automatically turns off after 6-15 minutes. In
this way, you can expect a much higher power
consumption, which will shorten the life of the
batteries.Automatic time setting (DST)
The integrated clock is programmed so that
it will automatically switch to summer or
winter time. During the summer time, the DST
information appears in the display.
Manually setting the time
If the station does not receive a time signal
automatically, the time can be set manually. If
a signal is received again, the set time is auto-
matically synchronized.
1. Press and hold down the DISPLAY SET (TIME
SET) (Fig. 1, 5) button for about 2 seconds until
the 12/24-hour format flashes.
2. Press CH + (Fig. 1, 3) or MEM- (Fig. 1, 4) but-
DE
GB
.
FR
NL
ES
IT
21