Bresser TemeoTrend SQ Mode D'emploi page 22

tons to switch between 12 - or 24-hour modes.
3. Press the DISPLAY SET button again to
switch for inputting the hours.
4. Press CH + (Fig. 1, 3) or MEM- (Fig. 1, 4)
buttons, to set the desired value.
5. Carry out the remaining settings as
described above in the following order: for the
time signals DCF (Germany) and MSF (UK):
12/24 Hr> hours> minutes> seconds> time
difference in hours.
6. Press the DISPLAY SET button again to save
the settings and exit the setting mode.
Pay attention: If your current time deviates
from the time, which the station automatically
receives, you can adjust the time deviation or
differing time zone.
For DCF/MSF: A time deviation of -23 to +23
hours can be set. After the time deviation is set,
the station displays the received time taking
into account the set time deviation.
Setting the alarm
1. Press the ALARM SET button (Fig. 1, 2) in
the display mode to select the alarm mode. The
22
selected alarm mode appears in the display
above the alarm time.
2. Press and hold down the ALARM SET (Fig. 1,
2) button in the alarm mode for about 2 seconds
until the hour display flashes.
3. Press CH + (Fig. 1, 3) or MEM- (Fig. 1, 4)
buttons, to set the desired value.
4. Press the ALARM SET button again to switch
for inputting the minutes. The minute display
flashes. Press CH + (Fig. 1, 3) or MEM- (Fig. 1, 4)
buttons, to set the desired value.
5. Press the ALARM SET button again to save
the settings and exit the setting mode.
Pay attention: The alarm time is set and the
alarm call will automatically follow at the
set time, if the corresponding symbol
displayed in the display.
Activate the alarm
1. Set the alarm as previously described.
2. Press the ALARM SET button (Fig. 1, 2) in
the display mode just once to activate AL.
The corresponding symbol is displayed in the
display. By pressing the button again, the alarm
is deactivated.
is