Weller WT 2M Mode D'emploi page 18

Error messages and error clearance
Message/symptom
Display: „- - -
•
No display function (display
•
OFF)
OFF
•
Tool remains cold
•
Temperature shown in the
•
display
Tool remains cold
•
Station is not operating as it
•
usually does
Settings cannot be changed
•
Zero Smog is not running
•
Possible cause
Tool has not been detected
•
Tool defective
•
Tool not compatible
•
No mains supply voltage
•
Station is on standby or in OFF mode
•
Station is on standby or in OFF mode
•
Heating defective
•
Parameters set incorrectly
•
Station locked
•
No mains supply voltage
•
No signal detected
•
ENGLISH
Remedial measures
Check connection of tool to device
•
Check connected tool
•
Turn on mains power switch
•
Check mains supply voltage
•
Check device fuse
•
Reactive the soldering tool using the UP
•
or DOWN buttons
Move the gun
•
Reactive the soldering tool using the UP
•
or DOWN buttons
Check/replace the soldering tool
•
Reset the station to the factory settings
•
Unlocking the station
•
Check the mains power supply
•
Check the interface wiring
•
Check the interface settings
•
EN
18