Technical Data; Using The Sprayer; Preparing The Equipment For Use - Birchmeier RPD 15 ATS Mode D'emploi

IV Technical Data
Model:
Dimensions (H x W x L):
Empty weight:
Operating pressure:
Max. permissible operating temp.:
Behälterinhalt:
Pumpe:
V Using the sprayer

1. Preparing the equipment for use

Check the package contents to ensure that they are complete and intact.
If you notice transport damage, please contact your dealer immediately.
Assembling the hose, trigger and spray tube.
Screw the pistol valve into the hose. Attach the spray tube to the pistol valve and tighten the union nuts.
Mount the hose onto the pump lever.
Assembling the pump lever (left-handed operation, pre-assembled delivery package)
Please follow the reassembly instructions on page 7 to reassemble for right-handed operation.
Move the pump lever into the assembly position (approx. 45° angle), note the shaft markings (cams on the
front and ridge without an indentation) and insert until it locks into position (first latch, adjustment position).
Turn the pump lever in the desired position as far as it will go (working or parking position) and insert fully until
it has completely locked into position (second latch, function position).
Assemble the intake suction hose.
RPD 15 ABR
610 mm x 400 mm x 220 mm / 2.0 ft x 1.31 ft x 0.72 ft
3.7 kg / 6.2 lb
– 5 bar / – 73 psi
-10 °C – 30 °C / 14 °F – 86 °F (Warning, risk of freezing!)
15 Liter / 4 US Gal
Piston pump
- 17 -