ProMinent DULCO Trans 50/1200 PP Mode D'emploi page 9

Safety instructions, Starting operation
 Regularly check the hose clamp for tight fit.
 Check outlet tube and seal for tight fit. If necessary,
tighten again outlet tube and/or replace seal.
 When using a hand nozzle with an attached key button,
only use the key button with a safety extra-low voltage.
Generally replace a defect signalling cable.
 Only use the hand nozzle with safety handle.
 Non-compliance with the safety instructions may cause
injuries to the operator, pollution of the environment or
damage to the hand nozzle.
Starting operation
 Ensure that the supply voltage corresponds with
the voltage indicated on the name plate.
 Never operate the pump unless the union nut between
motor and pump has been firmly tightened.
 Immerse the pump vertically into the liquid and secure it in a
vertical position by the use of a barrel fitting or a screw clamp.
 Always check power supply cable for damage
before starting operation.
 Keep solvents away from the power supply cable.
 Only switch the motor on when the pump is in the liquid.
 Before inserting the plug to the socket, ensure that
on/off-switch is set to "0" (Stop).
 Insert the plug.
 Switch on the motor.
Cleaning ater operation, Measures after use, Dismantling and Disposal
Cleaning after each operation
 Clean the pump by flushing an appropriate cleaning agent.
First pump the cleaning agent in circuit, then rinse with
clean detergent.
 Do not remove motor from the pump as long as there is
any back pressure.
 Before removing the motor from the pump, completely
drain pump, flexible hose and hand nozzle.
 Do not use flammable liquids to clean the pump.
 The pump and hose must be compatible with
the cleaning agent.
 The pump should not be immersed deeper into
the cleaning agent than the outlet connection.
Dismantling of pump for cleaning :
1. Remove the plug.
1. Release union nut between motor and pump.
2. Remove the motor.
3. Remove inner tube from the pump.
Measures after use
Attention!
 Empty pump, hose and fittings after every use.
 Drain hand nozzle after use. Otherwise liquid being
contained within the outlet tube will flow out without control.
Dismantling and Disposal
 Pump, hose and fittings must be emptied prior to dismantling.
 Prior to dismantling the outlet tube switch the pump off and
disconnect the mains.
 Collect environmentally harmful substances and liquids in
appropriate containers and dispose of them in an environmen-
tally sound manner.
 Dispose of scrap material and parts that cannot be repaired or
reused in an environmentally sound manner.
16 17