EUROM Sani-Fanheat 2000R Manuel D'utilisation page 38

The timer button

button on the unit.
Set the day and time:
Make sure that the unit is in standby mode (S) (use the main

switch). You can also set the day and time while the unit is
switched on.
Press the SET button

Use the plus and minus buttons
(from 0 to 23). Press SET again to see the minutes. The
display shows "30" and you can use the plus and minus
buttons to set the number of minutes, from 00 to 59.
Press SET again and the display will show
and minus buttons to set the day: Monday = d1, Tuesday =
d2, etc.
Finally, press
return to the mode it was in before you set the day and time.
Press SET to check the day and time.
Set the temperature:
Make sure the unit is switched on then press the plus or minus button; the

standard setting is "23". Press the plus or minus button
until you have reached the required temperature
(between 10°C and 35°C). Press OK to confirm the
setting. The display shows the set temperature and the
power, for example:
If you have set the temperature, the unit selects the

power required: full power if it needs to heat the room
by more than 2 °C and low power if it needs to heat the
room by less than 2 °C. Once the unit has reached the
set temperature, the heating element is switched off but
the ventilator remains switched on for another 3
minutes. This circulates the air in the room so that the
unit can sense whether the room is cooling down. The
unit returns to standby after 3 minutes. The unit switches on again if the room
cools down to 2 °C below the set temperature.
To turn the thermostat off, press the function button

low or full power. The unit will now work continuously. You no longer see the
temperature on the display, which shows Fig. B or Fig. C. If the unit has been
running continuously for 12 hours, it will switch off automatically, cool down and
return to standby.
Set the weekly programme:
To set a weekly programme, you first need to set the date and time.
1. Make sure that the unit is in standby mode (S) (use the main switch).
2. Switch the unit on using the on/off button
on the remote control works in the same way as the timer
once; the display now shows "12".
to confirm the settings. The display will
/ to set the hour
; use the plus
.
38
and select heating on