EUROM Sani-Fanheat 2000R Manuel D'utilisation page 37

Set-up and Operation
Make sure that the main switch is OFF (O)

Unroll the electrical cable entirely and insert the plug into a

suitable 220/240V socket.
Set the main switch to ON (l). The display will show "S"

(standby).
Manual operation using the buttons:
Press the F button once. The ventilator will switch on and the

display will show Fig. A.
Press the button again and the heating will switch on, on low power. The display

will show Fig. B.
Press the button a third time and the

heating will switch to full power. The
display will show Fig. C.
Press the button a fourthtime and the

unit returns to standby (S). The unit will
cool down for 3 minutes.
You can set a delayed start time using

the timer button
standby (S) and press the timer button,
this will be visible on the unit. Each time
you press the timer button, one hour is
added to the start time. The display shows the number of hours set and counts
down at the end of each hour. The timer lamp also switches on. The unit starts
automatically at the end of the set time. The standard temperature is 23°C
(note it is not possible to set the thermostat using the buttons).
If the weekly programme is not set and if no temperature has been set using

the remote control, the unit will switch off automatically after 12 hours.
Operation using the remote control:
Please note: the remote control only works if the emitter on the
remote control can make contact with the receiver on the unit.
Make sure that the unit is in standby mode (S) (use the main

switch).
Press the power button

display will show Fig. A.
Press the function button

power. The display will show Fig. B.
Press the button again and the heating will switch to full

power. The display will show Fig. C.
Press the function button a third time and the unit will return

to mode A.
. Set the unit to
to switch the ventilator on; the
to switch the heating on, on low
37