EUROM Sani-Fanheat 2000R Manuel D'utilisation page 36

Description
1. Main switch
2. Display
3. Timer
4. Function selector = Timer button
5. Suction grille (back)
6. Outlet grille (bottom)
Location and connection
Remove all packaging material and keep out of reach of children. After

removing packaging, check the appliance for damage or other signs that could
indicate a fault/defect/malfunction. In case of doubt, do not use the appliance,
but contact your vendor for inspection or replacement.
Select a suitable location for the device taking into account all the

aforementioned warnings in this manual.
The heater has to preferably (and definitely in
damp rooms) be positioned at and permanently
connected to an electric socket. This connection
may only be made by a qualified electrician and,
for that reason, is not described here.
In this booklet, for reasons of safety, use with a
plug should be assumed; when there is a
permanent connection, any passages about the
plug do not apply.
Drill 2 holes (8 mm.) in the wall at the selected spot: horizontal to one another

with a distance of 18,7 cm. Insert plugs into the holes and insert screws into the
plugs (included). Leave the screws protruding by 5 mm. Hook the heater using
the suspension eyes over the screws, slide it as far as possible to the left and
pull the heater downwards.
Attach the heater using the materials supplied (see diagram). Place the bracket

on top of the heater with the short side against the wall. Mark the location of
the hole on the wall and remove the heater. Drill a hole at the marked spot and
insert a plug. Now hang the heater in place and screw the bracket to the wall,
as shown in the diagram. The heater is now installed.
36