First Installation; Channel Scan - Philips DTR 300/00 Mode D'emploi

DTR 300 sans esp_140205.qxd
5

First installation

Requirements for fast and successful first installation are as
follows:
• You already have an aerial.
• Your aerial is correctly pointed at the terrestrial
transmitter corresponding to your area (1).
• Your digital receiver connection is according to the
diagram depicted in chapter 4.1 or 4.2.
• Your TV set is switched on.
- Connect your receiver to the mains.The receiver front
display gets on and the welcome screen appears.
- Press <OK> to proceed.The Setup screen appears.
5.1

Channel scan

The Setup screen appears.The selection is on Service scan.
t
- Press to scroll up to the setup option you want to
modify, and then press
- Press <OK> to start scanning for channels.
The following information is reported on screen:
- scanning progress,
- number of channels found.
When scanning is successfully completed, a completion
message is displayed.
- Press <OK>. A warning message is displayed.
- Press <OK> again to start watching TV.
To know more about using your digital receiver consult
chapter 6.
If scanning failed, proceed to chapter 5.2.
14/02/05 16:16
i
to access the option values.
Page 15
FIRST INSTALLATION 15