Product Description; Unpacking - Philips DTR 300/00 Mode D'emploi

DTR 300 sans esp_140205.qxd
- Do not install the receiver near any heat sources such as radiators, stoves or other apparatus
that produce heat. Protect it from direct sunlight.
- When installing the receiver, ensure there is a gap of approximately 2.5 cm around the receiver
to enable air to circulate freely and prevent overheating.
- Leave accessible the mains connector at the back of the unit in case emergency shutdown is
required.
- Do not place any combustible objects on the receiver (candles, etc.).
- No objects filled with liquids, such as vases, shall be placed on the unit.The receiver shall not be
exposed to dripping or splashing. Should this happen, disconnect your receiver from the mains
and consult your dealer.
- Make sure that children do not place any foreign objects in any of the openings.
- For cleaning, use a soft, damp (not wet) cloth. Never use any abrasive cloth and aerosol cleaners.
2

Product description

2.1

Unpacking

Unpack your receiver and check that the following cables and accessories are also included in the
package:
- 1 remote control
- 2 batteries (2 x LR6 AA 1,5 V)
- 1 SCART lead
- 1 RF coaxial lead
- 1 mains cord
- 1 user manual
- 1 Worldwide Warranty booklet
Plastic bags can be dangerous.To avoid suffocation keep the bag away from babies and
children
14/02/05 16:16 Page 7
PRODUCT DESCRIPTION 7