It-230 Programming Section; Programming Options; It-230 Communications Reporting Codes; Interactive Options - DSC IT-230 RS-422 Manuel D'installation

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

The Programming Sections in this document are accessed via panel Section for Ethernet/GPRS Programming.

Enter: [*][8][installer code][851][# # # ], where # # # is the 3 digit Section number referenced in this Program-

ming section. The worksheet at the end of this document can be used to record new values when programming

changes have been made from their default values. Default values are provided for each Section.

NOTE: Programmed values can not be modified using the keypad. Installers may review/record pro-

gramming Option values at the keypad.

Programming Options

[011] Installer Code

Default (CAFE)

Program your installer code for this IT-230 module. The installer code is required whenever programming of the

IT-230 module is required. Valid range: 0000 - FFFF.

[021] Account Code

Default (FFFFFF)

The Account Code is included when transmitting events generated by the IT-230. (e.g., Panel Absent Trouble). It is

recommended that the IT-230 Account Code be the same as the Panel Account Number. Valid range: 000001-

FFFFFE. If 4 digit account codes are needed the 2 lowest digits shall be programmed as FF;(e.g., Account Code

1234 is programmed as:1234FF). Programming this Section as all 0 or all F will cause a Module Configuration

Trouble (Trouble LED = 12 flashes).

NOTE: 12 flashes are indicated on the IT-230 only. This status is NOT communicated to the panel.

[022] Communications Format

Default (04)

The module can be configured to send IT-230 Events in SIA or CID format. Program 03 for CID. Program 04 for

SIA. The SIA communication format follows the level 2 specifications of the SIA Digital Communication Standard -

October 1997. This format will send the Account Code programmed in Section [021] along with its data transmis-

sion. The transmission will look similar to the following at the receiver: Nri0 ET001

Where: N = New Event; ri0 = Partition/Area identifier; ET = [023] Panel Absent Trouble; 001 = Zone 001.

IT-230 Communications Reporting Codes

Event

[023] Panel Absent Trouble

[024] Panel Absent Trouble Restore

[023] Panel Absent Trouble

Default (FF)

Program 00 to disable this event or FF to enable. This event will occur when communications with the panel have

been lost for more than 60 seconds.

[024] Panel Absent Trouble Restore

Default (FF)

Program 00 to disable this event or FF to enable. This event will occur when communications with the control panel

have resumed.

Interactive Options

[651] Interactive Account Code

Default (000000)

This section is programmed with the interactive Account Code of the IT-230.

[661] Interactive Baud Rate

Default (05)

This section is programmed with the baud rate used. Valid entries are provided in the table below. Default baud

rate is 115.2 KB.

HEX Value

Baud Rate