Chaser Mode With Integrated Programs; Midi And Dmx-Controlled Operation; Dmx-512 Connection / Connection Between Fixtures - EuroLite CLS-82 Mode D'emploi

Chaser Mode with integrated Programs

To set the desired mode (Chase, Receive, or Separate and Parallel) press the Mode button. The chosen
mode, Chase, Receive, or Separate and Parallel, can be seen on the LED display.
To change the desired parameters of the individual menus, first press the Menu button to get to the
respective menu, then press the Up/Down-buttons until the display shows the desired parameters.
Mode 1 - CHASE
Menu Parameter
Program P:01 – P:16
Menu Parameter
Speed SP:01 – SP:99
Menu Parameter
Dimmer d:000 – d:100

MIDI and DMX-controlled operation

You can control the projectors individually via your DMX-controller. Every DMX-channel has a different
occupation with different features.

DMX-512 connection / connection between fixtures

The wires must not come into contact with each other, otherwise
Only use a stereo shielded cable and 3-pin XLR-plugs and connectors in order to connect the controller with
the fixture or one fixture with another.
Occupation of the XLR-connection:
If you are using controllers with this occupation, you can connect the DMX-output of the controller directly
with the DMX-input of the first fixture in the DMX-chain. If you wish to connect DMX-controllers with other
XLR-outputs, you need to use adapter-cables.
Building a serial DMX-chain:
Connect the DMX-output of the first fixture in the DMX-chain with the DMX-input of the next fixture. Always
connect one output with the input of the next fixture until all fixtures are connected.
Caution: At the last fixture, the DMX-cable has to be terminated with a terminator. Solder a 120
between Signal (–) and Signal (+) into a 3-pin XLR-plug and plug it in the DMX-output of the last fixture.
the fixtures will not work at all, or will not work properly.
21/44
Ω
resistor
41907070_V_1_0.DOC