Publicité
Les langues disponibles
Les langues disponibles
CHARGER BATTERY 200W TE43
Fig. 4
Read the instructions leaflet careully before recharging.
For indoor use only/Do not leave out in the rain
DESCRIPTION:
The TE43 is a Power Supplier/Charger for lead storage batteries. The batteries must have nominal voltage of
12V and a capacity of no less than 45Ah.
OPERATION:
The battery charger uses an algorithm which makes it possible to significantly reduce recharging time and avoid
permanent damage to batteries.
It starts charging at maximum current until the battery reaches a voltage value of 14.4V, then charging takes place
at a constant voltage of 13.8V. In this state the recharge current gradually decreases and the battery can be left
permanently connected to the charger without causing it any damage.
When it is fitted to a battery the power supplier immediately provides the required current, so that the battery
does not go flat (this is so only if the charging current is lower than the maximum current the power supplier can
deliver, otherwise the battery will go flat in any case with an amount of current equal to the difference between
I
- I
).
LOAD
BATTERY CHARGER
The TE43 battery charger also operates as a power supplier with fixed output current and voltage limited to
13.8V.
ATTENTION:
·Keep the equipment in a dry, well-aired place.
·Do not carry out any maintenance without disconnecting from the 230V mains.
·Do not recharge batteries that are not rechargeable.
·Disconnect the power supply before connecting or disconnecting the battery connection.
·When acid lead batteries are charged an explosive gas is produced internally: avoid flames or sparks and make
sure the battery is in a well-aired place.
If the power supply wire or battery connection clamps are damaged they must be replaced with items of the same
type, available from the manufacturer or after-sales service.
TECHNICAL CHARACTERISTICS:
·Input 230V ±20% 50/60Hz 1.5A
·Maximum power: 200W
·Maximum output current: 15A continuous (17A with temperature compensation)
·Operating cc voltage at end of recharge: 14.4V
·Maintenance voltage: 13.8V
·Remote signal for Power On Led
PROTECTION:
·Input fuse: 5A 250V Delayed 5x20 (internal fuse)
·Protection from pole inversion, with 30A auto type fuse (internal fuse)
·Overloading protection
·Short circuit protection
·Overheating protection
CONNECTIONS:
·230V input: Mate-N-Lok 3-pole AMP connector
·12V output: Fastin Faston 3-way connector
Red: (+), Black: (-), White: Power On.
2
We recommend short connections between the power supplier and battery, with 6 mm wire.
DIMENSIONS and WEIGHT:
· 142 x 190 x H82mm 1.6Kg
Publicité
