Sportplus SP-TM-4216e Mode D'emploi page 58

TROUBLESHOOTING - PROBLEMS WITH THE COMPUTER DISPLAY
Error message Cause
E01
E02
E03
E04
E05
Nothing
shown on all
screens after
switching on.
No error code,
no function of
the walking
belt.
SP-TM-4216e-IM-06-DE+GB+FR .indb 58
Connection error
between computer
board and motor
control board.
Error on motor
binding of relay.
Error on speed
sensor line.
Error on incline
function.
Over current.
Error on
transformer.
Error on control
board.
Solution
Check if the cables
between computer
board and motor
control board are well
connected.
Check if the cables are
well connected to the
motor or not.
Check if the speed
sensor cable is well
connected or not.
Check if the position of
the sensor is correct or
not.
Check if the signal wire
and the AC single line
of the incline motor are
well connected or not.
Check if the walking belt
is stuck or stopped by
something.
Check the loading.
Check if the overload
protector is in ON
position or not.
Check if the connecting
wires among power
switch, overload
protector and the motor
control board are well
connected or not.
Check if cables
connected to the motor
are well fixed or not.
58
Further action
Replace the
connecting cable.
Replace the
computer board.
Replace the
transformer.
Replace the motor.
Replace the motor
control board.
Replace the speed
sensor cable.
Replace the sensor.
Replace the motor
control board.
Replace the incline
cable.
Replace the incline
motor.
Replace the motor
control board.
Apply small
amount of lubricant
provided on the
running deck.
Replace the motor.
Replace the motor
control board.
Reset the overload
protector to ON
position.
Replace the
transformer.
Replace the motor
control board.
15/6/2016 18:41