EUROM Sail Manuel D'utilisation page 23

 Seek a location in the ceiling that fulfils all of the
requirements;
 Drill a sufficiently deep hole with a diameter of 8 mm;
 Knock the key-bolt with hanging eye into the hole;
secure it by turning clockwise and check that the
hanging eye is screwed into the key-bolt properly or
that the bolt and eye is firmly attached. Ensure that
the attachment kit can bear the weight of at least 10
kg.
 Attach the attachment chain with the screw locking at the Partytent heater.
 Hook a karabiner hook at the ring of the attachment chain
 Hang the party-tent heater on the hanging eye with the karabiner hook so that
the party-tent heater is 50 cm from the ceiling.
 Check that the karabiner hook is correctly closed.
2. Hanging on a frame (e.g. a tent frame)
Make sure that the party-tent heater can hang freely from the attachment point
you have selected and that it is sufficiently sturdy to bear the weight of the heater.
Secure it properly so that it cannot sag, slide or move in any other way.
 Seek a location in the frame that fulfils all of the requirements;
 Use the additional security chain with a karabiner hook at each end to secure
effectively:
- Hook the security chain to the ring on the hanging chain that is attached to the
party-tent heater, using the karabiner hook;
- Wind the security chain around the frame once or twice;
- Then attach the second karabiner hook also to the ring at the hanging chain;
this will ensure that the party-tent heater remains 50 cm from the frame.
 Check that the karabiner hook is closed properly and that the party-tent heater is
securely attached. It should not slide, sag or move at all!
Take care! The control box must be positioned at least 50 cm from the tent
canvas, cover or any other item!
The following applies to both methods
 Run the electrical cable along the hanging chain and secure at multiple points
with a tie-wrap. Make sure that the cable is tight along the chain but do not hang
the device on the cable! Run the electrical cable from the (hot) party-tent heater
to a socket.
 Your partytent heater is now ready for use.
23