Cola WAVE Manuel D'installation, D'utilisation Et D'entretien page 48

After a certain time has elapsed, if the fume temperature has not reached the minimum permissible value the stove
goes in alarm status.
- Do not use flammable liquids to light the stove.
- In case of persistent failed lighting, contact the Service Centre.
4.4 Work stage
After the 'STARTUP' stage, the stove goes to the 'WORK' mode which represents the normal operation mode.
The user can adjust the heat output from the max. value of 5 to a min. of 1 with the buttons 'P5' and 'P6'.
As well as adjusting the heat output, it is also possible to adjust the room temperature directly on the control panel
with the buttons 'P1' and 'P2': the display shows the current SET temperature status.
For the ventilation of hot air, the stove automatically regulates the speed according to the set heat output
Button 'P1'
Button 'P2'
- Make sure to check the pellet level in the hopper so that the flame does not go out due to lack of
pellets.
- Make sure the stove is off when loading pellets.
- The pellet hopper lid must always remain closed; it must only be opened when loading fuel.
- The bags of pellets must be kept at least 1.5 m from the stove.
When the room temperature has reached the set value or the
fume temperature has reached the max. set value, the output is
automatically brought to the min. value, MODULATION status.
If the STANDBY mode is activated, the stove is shut down with a
delay time after reaching the SET temperature. Restart occurs
when the room temperature is lower than a certain fixed value with
respect to the room temperature.
Clock
Dialogue box
Room temperature set value
Dialogue box
Room temperature
Output set to 4
Clock
48
Button 'P6'
Button 'P5'
Room temperature
Dialogue box Output
WAVE acciaio – vetro 2011
.