Brandt TV222 Série Guide D'utilisation Et D'installation page 5

9962 5581.qxd 24/09/02
Connection
If the cable is damaged, it must be replaced by the manufacturers, their After Sales Service or another
similarly qualified person for avoiding any possible risk of accident.
When the power
code appears on the control panel. This disappears automatically after
about 30 seconds
panel. This is normal, as the display is for use by the after-sales service when required. The user must not
take this into account under any circumstances.If the unit has a 3 phase 400 V2N connection, and is not
working correctly, check that the neutral wire is correctly connected. This precaution should also be taken
for all your other electronic apparatus.
230V
1
L1
2
3
N
4
You must use a 32
Amp fuse on your ins-
tallation
15:12 Page 5
Installing your hob in complete safety
is switched on, or after
or as soon as any
400v 2N
L1
1
2
L2
3
N
4
You must use a 16
Amp fuse on your ins-
tallation
5
a long power failure,
touch control is touched
Your hob must be connected to the mains with:
- A H05RRF type cable with three 2.5 mm² conduc-
tors or five 1.5 mm² conductors (including a yellow /
green earth wire)
- A plug that complies
recommendations or an all-pole circuit breaker with
contacts that open by at least 3 mm.
230 V∼ ∼ 50 Hz
Total energy consumption:
TV222.....6,4 kW
TV224.....6,3 kW
TV282.....6,9 kW
a light
on the
to CEI 83