Westfalia 317 056 Notice De Montage Et D'utilisation page 31

Installation instructions:
Disassemble the rear bumper and the reinforcement (will not be replaced). Screw the fastening screws
1.)
of the reinforcement back into the existing bore holes and seal with a standard anticorrosive agent if
necessary. The bumper reinforcement should be reassembled to the vehicle if the towing device is
disassembled at a later date.
If necessary, disassemble the spare wheel, loading edge cover, lateral boot interior lining, covers
underneath the rear lights and the rear lights.
2.) Remove the exhaust system's end silencer and disassemble the rear thermal-insulation plate.
Remove two pieces of lamination on both the right and left-hand chassis beam in order to reach the
fixing points for the towing device on the vehicle.
3.) From the rear, insert the base part 1 through the available holes in the chassis beam, align and attach it
to the vehicle at point "a" using the M10x35 bolts and the 10.5x30x3 washers in the available
attachment bore holes.
Tightening torque: M10x35 = 55 Nm
4.) Saw a portion out of the underside of the bumper in the middle as indicated on the supplied template.
The line "Y0" corresponds to the middle of the vehicle.
Now assemble the bumper to the vehicle.
If necessary, reassemble the spare wheel, loading edge cover, lateral boot interior lining, covers
underneath the rear lights and the rear lights.
Subject to alteration.
31