Operating The Brakes; Transfer In And Out The Scooter; Correct Position In The Scooter; Driving The Scooter - Vermeiren Venus 4 Sport Mode D'emploi

To reassemble, please proceed as follows:

Mount the front and rear frames in each other (see "Mounting or removing the rear and front
frame" chapter).

Move the steering column upwards (see "Adjusting angle of the steering column" chapter).

Mount the shopping basket (see "Mounting / removing the shopping basket" chapter).

Unlock the front wheels (see "locking steering wheels" chapter).

Mount the battery housing (see "changing the batteries" chapter).

Mount the seat (see "Adjusting the seat" chapter).

Fold the backrest to the back (see "Folding the backrest" chapter).

Place the freewheel drive lever in driving (see "Neutral" chapter).
2.4

Operating the brakes

Let go of the joystick to stop the scooter and activate the regular brakes / electromagnetic brakes.
2.5

Transfer in and out the scooter

1. Park the scooter as close as possible to the place where you want to transfer.
2. Check that the control panel (scooter) is switched off.
3. If necessary: put the armpad on the side you want to transfer upwards.
4. Transfer to / from the seat of the scooter.
2.6

Correct position in the scooter

Some recommendations for a comfortable use of the scooter:
1. Position your backside as close as possible to the backrest.
2. Make sure your upper legs are horizontal.
2.7

Driving the scooter

L
WARNING:
Risk of burns – Be careful when driving in hot or cold environments
(sunshine, extreme cold, saunas, etc.) for a sufficient amount of time and when
touching - Surfaces can assume the environment temperatures.
L
WARNING:
Risk of unsafe settings - Use only the driving characteristics described in
this manual.
2.7.1 Preparing the scooter for use
When you use your scooter for the first time, make sure that it is standing on level ground. All wheels
must be in contact with the ground.
1. For first time use, fully recharge the batteries.
2. Make sure that the motor is engaged.
3. Set the steering column in the most comfortable position (angle) for yourself and make sure it
has been secured properly.
4. See that the seat has been locked in the driving position.
5. Sit down on the seat and verify that both armpads are folded down so you can rest your arms
on them.
6. Insert contact key and turn clockwise, please wait for at least 3 seconds before you press the
speed lever otherwise you have a "delay protection" alarm.
7. Check the battery indicator and see that there is enough power for your trip. If not enough
capacity recharge the batteries before departure.
Now put the speed switch on the operator control to the minimum position. Your scooter is now ready
for use. Only use higher speed setting when you are confident that you can easily operate and control
your scooter.
Before using the scooter in busy or potentially dangerous areas, familiarize yourself with the operation
of your scooter. Please practice in a wide and open area like a park.
Page 11
Venus 4 Sport
2015-08