Assembly And Disassembly Of The Scooter - Vermeiren Venus 4 Sport Mode D'emploi

If this is not possible or you are on your own, you can carry the scooter by following steps:
2.3

Assembly and disassembly of the scooter

L
WARNING:
Risk of injury - Make sure that all parts are assembled properly.
L
WARNING:
Risk of injury - Assembly and disassembly must be done by trained
personnel (e.g. specialist dealer).
L
WARNING:
Risk of injury - Be careful not to cut or bruise yourself with the cables.
L
WARNING:
Risk of injury - Turn the scooter off before disassembly / assembly.
L
WARNING:
Risk of injury - Secure the starknob of the steering column after assembly of
your scooter.
L
CAUTION:
Risk of pinching - Do not place fingers between the components of the
scooter (frame, backrest).
The scooter can be disassembled in to four pieces, the seat (weight 5,6 kg), the front frame (weight
19,90 kg),the rear frame (12,85 kg) and battery housing (weight 13,60 kg), without any tools.
To disassemble, please proceed as follows:

Switch the scooter off.

Check that the scooter is placed in driving with the freewheel device lever (see "Neutral" chapter).

Fold the backrest to the front (see "Folding the backrest" chapter).

Remove the seat (see "Adjusting the seat" chapter).

Unlock the battery housing and lift these out the scooter (see "changing the batteries" chapter).

Lock the front wheels by pushing this lever down (see "locking steering wheels" chapter).

Remove the shopping basket (see "Mounting / removing the shopping basket" chapter).

Fold the steering column down (see "Adjusting angle of the steering column" chapter).

Remove the rear and front frame out each other (see "Mounting or removing the rear and front
frame" chapter).
1. Switch the scooter off.
2. Remove loose parts (seat, battery housing,
shopping basket).
3. Store loose parts in a safe place.
4. Dissasembly the rear and front frame.
Page 10
Venus 4 Sport
2015-08