Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Section
03
Installation
! The cords must not cover the area shown
in the figure below. This is necessary to
allow the amps and navigation mechanism
to dissipate heat.
! The semiconductor laser will be damaged
if it overheats, so don't install the naviga-
tion unit anywhere hot — for instance, near
a heater outlet.
Parts supplied
Parts marked (*) are supplied with AVIC-
X930BT and AVIC-X9310BT.
The navigation unit
Flush surface screw
(5 mm × 9 mm)
(8 pcs.)
22
En
Do not cover this area.
Binding screw
(5 mm × 8 mm)
(8 pcs.)
Screw*
(2 mm × 4 mm)
(1 pc.)
Installation using the screw holes
on the side of the navigation unit
% Fastening the navigation unit to the
factory radio-mounting bracket.
Position the navigation unit so that the brack-
ets screw holes and its screw holes are
aligned, and tighten the screws at three or
four locations on each side.
Use either the binding screws (5 mm × 8 mm)
or flush surface screws (5 mm × 9 mm), de-
pending on the shape of the bracket's screw
holes.
If the pawl interferes with installation,
you may bend it down out of the way.
Factory radio-mounting bracket
Binding screw or
flush surface screw
Be sure to use the
screws supplied
with this navigation
system.
Dashboard or console
Publicité
Chapitres
Table des Matières
