Installing The Gps Antenna; Installation Notes; Parts Supplied - Pioneer AVIC-Z130BT Manuel D'installation

Masquer les pouces Voir aussi pour AVIC-Z130BT:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Section
03
Installation

Installing the GPS antenna

CAUTION
Do not cut the GPS antenna lead to shorten
it or use an extension to make it longer. Alter-
ing the antenna cable could result in a short
circuit or malfunction and permanent da-
mage to the navigation system.

Installation notes

! The antenna should be installed on a level
surface where radio waves will be blocked
as little as possible. Radio waves cannot be
received by the antenna if reception from
the satellite is blocked.
Dashboard
! When installing the GPS antenna inside
the vehicle, be sure to use the metal sheet
provided with your system. If this is not
used, the reception sensitivity will be poor.
! Do not cut the accessory metal sheet. This
would reduce the sensitivity of the GPS an-
tenna.
! Take care not to pull the antenna lead when
removing the GPS antenna. The magnet at-
tached to the antenna is very powerful, and
the lead may become detached.
! Do not paint the GPS antenna, as this may
affect its performance.
24
En

Parts supplied

Rear shelf
GPS antenna
Metal sheet

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Avic-x930btAvic-x9310bt

Table des Matières