Recommended Precautions - Silk-n BellaVisage H2111 Mode D'emploi

3. For your first treatment, start at energy level 1 for a few minutes,
then set an energy level that is comfortable for the area you
wish to treat. For future treatments, you can use an energy level
that is comfortable for the area you wish to treat.
Next, spread a thin layer of Silk'n slider gel over the area. Always
4.
apply slider gel (or another water-based clear gel) before you
put the device on your skin.
Press the treatment surface (# 1 in the diagram) firmly against
5.
your skin. You will feel a mild sensation of warmth. Move the
device in gentle massage-like linear motions on the area you
wish to treat. Progress slowly and carefully. Work each treatment
area for 10-15 minutes.
Make sure the treatment surface is in good contact with
a
your skin.
6. Immediately after the treatment, wash your face to remove any
gel, then apply facial lotion or a mask.

9.2 Recommended precautions

Always remove all jewelry before use.
U
Do not leave the device on one spot. Keep continuous
U
movement covering the entire treatment area. This will prevent
overheating of the treatment area and reduce the possibility of
any adverse effect.
Make sure the 3 electrodes (#2 in the diagram) are always in
U
full contact with the skin.
If the energy level feels uncomfortable, move the device more
U
quickly around the area, or immediately reduce the energy
level.
Only change energy levels when the treatment surface is
C
not in contact with the skin.
C
Stop immediately if you feel any discomfort.
9
EN