VQ OrthoCare BioniCare Knee System Manuel D'utilisation page 14

BioniCare Knee System
®
Preparation and Treatment (cont.)
STEP 4. Starting Your Treatment
1. Check that the electrodes are in place and all connections and adjust-
ments are correct.
2. Turn the BioniCare Generator on by pressing the Select/Power button
until BioniCare appears on the screen. Unlock the device by pressing
the lock on the screen or the
the main treatment menu.
3. Press the
4. Increase the stimulation by pressing the Increase Button
screen or the corresponding manual button. Increase until you feel a
tingling sensation in the thigh or knee.
5. Press the Decrease Button
manual button a few times to reduce the stimulation just enough so
you no longer feel the tingling sensation. You have now begun your
treatment.
Note: The BioniCare Generator must be set at 2.0V or greater. If the voltage is set
below 2.0 V, the device will begin to beep after 5 minutes and will turn off after 10
minutes.
Note: Optimal Treatment time is 6 - 10 hours per day (minimum) or as much as
possible.
BioniCare System Removal Steps:
STEP 1. Unhook knee wrap from straps and carefully peel from knee.
Place clear plastic backing onto knee electrode for protection when not in use.
STEP 2. Remove brace. Place clear plastic backing onto thigh electrode.
Note: There is no need to remove the electrodes from the Night-Wrap upon removal.
Leave the electrodes in place and cover the electrodes with the clear backing to
keep the electrodes clean and to prevent them from prematurely drying.
12
button. The screen will then advance to
play button.
on the touch screen or the corresponding
on the touch