VQ OrthoCare BioniCare Knee System Manuel D'utilisation page 13

STEP 2. Apply the BioniCare Night-Wrap
• Remove the clear backing from both electrodes.
Position the wrap so that the electrodes are
facing leg (keep long strap closer to the waist).
• Center the small round area of the electrode
over the patella, and gently press the knee
electrode to the knee while keeping the thigh
portion of the wrap away from the leg.
• While grasping the top edge of the wrap, gently
tension it, and then adhere the thigh electrode
to the skin.
• Wrap the straps around the leg and secure hook-
tabs to the wrap. Straps may be trimmed as
needed. Best performance is achieved when the
lower strap crosses over the patella, wrapping
the patella in two layers.
STEP 3. Connecting the Device:
The lead wire connects the BioniCare Generator to the knee and thigh
electrodes. The single end of the Wire inserts into the female connector on
the generator and the other end divides into two ends with color-coded tips.
See Figure 1 and 2, to attach this Wire:
1. Connect the two color coded lead wire ends to the electrode wires. Make
sure the BioniCare Generator is turned off. Attach red (knee) electrode
to the red lead wire tip and the black (thigh) electrode to the black lead
wire tip.
2. Now connect the single lead wire end to the BioniCare Generator as seen
in figures 1 and 2.
LONG STRAP
KNEE
ELECTRODE
Figure 1
BioniCare Knee System
®
Figure 2
THIGH
ELECTRODE
KNEE
ELECTRODE
ROUND AREA
OF ELECTRODE
PATELLA
KNEE
ELECTRODE
ENGLISH | 11