Charging Mode Nimh-Nicd Batteries - XciteRC X-PERT X90T Mode D'emploi

EN

Charging mode NiMH-NiCd batteries

The following types of Ni-batteries can be charged: NiMH - NiCd
28
Charging mode NiMH-NiCd batteries
Cut-off temperature which is measured by the
temperature sensor (not included).
Press to go back to the charge menu.
This display shows the voltage curve for
charging or discharging.
Press to go back to the charge menu.
Note: if the voltage of the battery is lower
than 2.5 V (single-cell), the Delta-Peak
voltage may not be detected properly, which
may result in an overcharge.
WARNING: for safety reasons use a
temperature sensor or set the
charging current above 1C - fire
hazard!
Menu Settings
You may set the number of cells (CELLS),
capacity (CAPAC), current (CURR) and Delta-peak
voltage ( p ). The adjustable current ranges from
0.1 - 10.0 A.
In the middle of the display the number of cells the
charger detects is shown. If the number is correct
and suits with your settings, press the START
button. Otherwise correct with CELLS.
Delta-Peak: set the delta-peak p value (5 - 20
X-pert Charger X90T