Charging Mode Pb-Batteries - XciteRC X-PERT X90T Mode D'emploi

EN

Charging mode Pb-batteries

This is programmed for charging a Pb battery with nominal voltage from 2 - 20 V - a Pb battery can not be
charged repidly. It can only deliver relatively low current compared to its capacity. The optimal charge current
will be 1/10 of the nominal capacity. Always follow the instructions supplied by the battery manufacturer.
30
Pb Charge Menu CHG
You may set the number of cells (Pack.),
capacity (CAPAC), current (CURR) and
end-of-charge voltage
adjustable current ranges from 0.1 - 10.0
A. Start the charging process by pressing
Enter for more than 2 seconds.
Pb Discharge Menu DCHG
In this menu you set the number of cells
(Pack.), capacity (CAPAC), current (CURR)
and end-of-discharge voltage (ENDV). The
adjustable current ranges from 0.1 - 2.0 A.
Start the discharging process by pressing
Enter for more than 2 seconds.
After connecting the battery and press
START once, the charger is checking the
battery and displays OK.
To start the charging process press
START, to stop and check the settings
again press BACK.
Charging mode Pb-batteries
(ENDV). The
X-pert Charger X90T