Turning Power On/Off - Sharp PN-70SC3 Manuel D'installation

Caution
• When all connections are complete, turn on the power.
• Turn on the monitor first before turning on the computer or
playback device.
• Even when the power is turned off with the POWER button
on the monitor, a minute amount of power is consumed if
the power cord is connected.

Turning power on/off

1. Press the POWER button on the side of the monitor to
turn on the power.
The power LED lights green.
Remote control sensor
Status
Green lit
Red lit
2. Turn the power on and off with the POWER button on
the remote control.
Point the remote control unit toward the remote control
sensor on the monitor, and press the POWER button.
Caution
• When turning the power off and back on, always wait for at
least 5 seconds. A short interval may result in a malfunction.
• For a complete electrical disconnection, pull out the main
plug
Turning Power On/Off
Power LED
Status of the monitor
Power on
Standby mode
nOperation mode
When the monitor is turned on for the first time after being
shipped from the factory, the operation mode setting screen
will be displayed. Set it to MODE1 or MODE2.
MODE1 ... OFF IF NO OPERATION is set to 4HR.. (These
settings can not be changed.)
If there is no operation for 4 hours or more, the
monitor automatically enters standby mode.
MODE2 ... Will perform standard operation.
OFF IF NO OPERATION is set to DISABLE. These
settings can be changed.
Even after being set, changes can be made using
OPERATION MODE, located in the menu of the monitor. (See
OPERATION MANUAL.)
7
E