Starting And Stopping - Husqvarna 3120XP Manuel D'utilisation

Starting and stopping

WARNING! Note the following before
!
starting:
Never start a chain saw unless the bar,
chain and all covers are fitted correctly.
Otherwise the clutch can come loose and
cause personal injuries.
Always move the machine away from the
refuelling area before starting.
Place the machine on firm ground. Make
sure you have a secure footing and that
the chain cannot touch anything.
Keep people and animals well away from
the working area.
Cold engine
Starting: The chain brake should be activated when
starting the chain saw. Activate the chain brake by
pushing the front hand guard forwards.
Ignition: Slide the ignition switch to the left.
Choke: Set the choke control in the choke position.
Start throttle: Press the throttle lockout (1). Open throttle
fully (2). Press in button (3).
3
2
STARTING AND STOPPING
1
If the machine is fitted with a decompression valve (A):
Press the valve to reduce the pressure in the cylinder and
make starting easier. You should always use the
decompression valve when starting the machine. Once
the machine has started the valve will automatically return
to its original setting.
Warm engine
Use the same starting procedure as for a cold engine but
without setting the choke control in the choke position.
Starting
Grip the front handle with your left hand. Hold the chain
saw on the ground by placing your right foot through the
rear handle. Pull the starter handle with your right hand
and pull out the starter cord slowly until you feel a
resistance (as the starter pawls engage) then pull firmly
and rapidly. Never twist the starter cord around your
hand.
CAUTION! Do not pull the starter cord all the way out and
do not let go of the starter handle when the cord is fully
extended. This can damage the machine.
–
English 21