Storage - Makita EN4950H Manuel D'emploi Et De Sécurité

STORAGE

WARNING: When draining the fuel, stop the engine and wait for the engine
to cool down.
Failure to do so may cause burns or fire.
ATTENTION: When you store the machine for a long time, drain all fuel from
the fuel tank and carburetor, and keep it at a dry and clean place.
- Drain fuel from the fuel tank and carburetor according to the following procedure:
1) Remove the fuel tank cap, and drain fuel completely.
If there is any foreign materials remaining in the fuel tank, remove it completely.
2) Pull out the fuel filter from the refill port using a wire.
3) Push the primer pump until fuel is drained from there, and drain fuel coming into
the fuel tank.
4) Reset the filter to the fuel tank, and securely tighten the fuel tank cap.
5) Then, continue to operate the engine until it stops.
- Remove the spark plug, and drip several drops of engine oil through the spark
plug hole.
- Gently pull the starter handle so that engine oil will spread over the engine, and
attach the spark plug.
- Attach the cover to the cutting blades.
- In general, store the machine in horizontal position. If it is not possible, place the
machine as the motor unit comes below the cutting tool. Otherwise engine oil
may leak from inside.
- Always pay attention to storing the machine in a safe place to prevent machine
damage and personal injury.
- Keep the drained fuel in a special container in a well-ventilated shade.
Drain fuel
22
Humidity