Before First Use - Electrolux GA55SLV220 Notice D'utilisation

If you stop to use the combi
detergent tablets, before you start to
use separately detergent, rinse aid
and dishwasher salt, do these steps:
1. Set the water softener to the highest
level.
2. Make sure that the salt container and
the rinse aid dispenser are full.
3. Start the shortest programme with a
rinsing phase, without detergent and
without dishes.
4. Adjust the water softener to the water
hardness in your area.
5. Adjust the released quantity of rinse
aid.
5.4 Acoustic signals
The acoustic signals operate in these
conditions:
• The programme is completed.
• The level of the water softener is adjus-
ted electronically.
• The appliance has a malfunction.
Factory setting: On.
It is possible to deactivate the
acoustic signals.
Deactivating the acoustic signals
1. Press the on/off button to activate the
appliance. Make sure that the appli-
ance is in setting mode, refer to "Set-
ting and starting a programme".
2. Press and hold, at the same time
touchpads (4) and (5) until the indica-
tors of touchpads (3), (4), (5) and (6)
flash.
3. Press touchpad (5),
• The indicators of touchpads (3), (4)
and (6) go off.
• The indicator of touchpad (5) contin-
ues to flash.

6. BEFORE FIRST USE

1. Make sure that the set level of the wa-
ter softener agrees with the water
hardness in your area. If not, adjust
the water softener. Contact your local
water authority to know the water
hardness in your area.
• The display shows the current set-
ting of the acoustic signals.
4. Press touchpad (5) to change the set-
ting.
5. Press the on/off button to deactivate
the appliance and to confirm the set-
ting.
5.5 Setting the TimeBeam
colour
Nine colours are available for this light
beam. You can change the colour or de-
activate it.
1. Press the on/off button to activate the
appliance. Make sure that the appli-
ance is in setting mode, refer to "Set-
ting and starting a programme".
2. Press and hold, at the same time
touchpads (4) and (5) until the indica-
tors of touchpads (3), (4), (5) and (6)
start to flash.
3. Press touchpad (6).
• The indicators of touchpads (3), (4)
and (5) go off.
• The indicator of touchpad (6) contin-
ues to flash.
• The display shows a number and
the letter C. Each number is related
to a different colour (0C = Time-
Beam deactivated).
4. Press touchpad (6) again and again to
change the colour.
5. Press the on/off button to deactivate
the appliance and to confirm the set-
ting.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
4. Open the water tap.
5. Processing residues can stay in the
appliance. Start a programme to re-
ENGLISH 61
On
Off