Electrolux GA55SLV220 Notice D'utilisation page 64

64 www.electrolux.com
5. Set and start the correct programme
for the type of load and the degree of
soil.
7.1 Using the detergent
A
7.2 Setting and starting a
programme
Setting mode
For some settings it is necessary that the
appliance is in setting mode.
Press the on/off button to activate the ap-
pliance. The appliance is in setting mode
when the display shows 2 horizontal sta-
tus bars. If the control panel does not
show this condition, press Reset.
Starting a programme without
delay start
1. Open the water tap.
2. Press the on/off button to activate the
appliance. Make sure that the appli-
ance is in setting mode.
3. Press Program again and again until
you see in the display the number of
the programme you want to set. The
programme number flashes. If you
want you can set the applicable op-
tions.
4. Close the appliance door, the pro-
gramme starts. The programme dura-
tion starts to decrease with steps of 1
minute.
Starting a programme with delay
start
1. Set the programme.
B
30
A
20
+ -
C
1.
Press the release button (B) to open
the lid (C).
2. Put the detergent in the compartment
(A) .
3.
If the programme has a prewash
phase, put a small quantity of deter-
gent on the inner part of the appli-
ance door.
4. If you use detergent tablets, put the
tablet in the compartment (A).
5.
Close the lid. Make sure that the re-
lease button locks into position.
2. Press Delay again and again until the
display shows the delay time you want
to set (from 1 to 24 hours).
• The delay time flashes in the dis-
play.
• The Delay indicator comes on.
3. Close the appliance door. The count-
down starts.
• When the countdown is completed,
the programme starts.
Cancelling the delay start while
the countdown operates
When you cancel the delay start, also the
programme is cancelled.
1. Press Reset. The display shows 2
horizontal status bars.
2. Set the programme again.
Cancelling the programme
1. Press Reset. The display shows 2
horizontal status bars.
Make sure that there is detergent
in the detergent dispenser before
you start a new programme.
At the end of the programme
The display shows 0 and the end indica-
tor comes on.
1. Press the on/off button to deactivate
the appliance.