Cola AQUAPLUS 23 Manuel D'installation, D'utilisation Et D'entretien page 53

Les langues disponibles

4.7.1 Replacing the battery

The remote control (model with 6 button) is powered by a 3-volt CR2025 type battery (included) located in the bottom

of the device. Also remove the insulation before use. For its insertion and possible replacement, proceed as follows:

- Operate the lever indicated;

- Pull out the battery tray and replace the battery (3-volt CR2025 model) respecting the polarity;

- Insert the tray;

- Check proper functioning.

- Keep the remote control away from direct heat sources and water.

- The remote control battery must be replaced and disposed of safely in compliance with

local regulations;

4.8 Thermostat - external chronothermostat

To use an external thermostat, contact an authorised technician and proceed as follows:

turn off the power by means of the main switch on the back and detach the power

cable;

remove the side panel to access the electronic controller;

referring to the wiring diagram, connect the two wires of thermostat to the respective

board TERM terminals;

refit everything and check correct operation.

The setting procedure is as follows:

- external thermostat: SET in the menu M-6-7 in T-AMBIEN;

- external chronothermostat: SET in the menu M-6-7 in T-AMBIEN and disable the

All the menu functions do not change for each of the settings and signalling of the

connection occurs with lighting up of the segment LED on the status bar of the display.

4.9 Idle period (end of season)

If the stove is not used for long periods, or at the end of each season, it is advisable to proceed as follows:

- remove all the pellets from the hopper;

- disconnect the power supply;

- clean thoroughly and, if necessary, have any damaged parts replaced by qualified personnel;

- protect the stove from dust with suitable covering;

- store in a dry and safe place protected from atmospheric agents.

Button P3: Stove lighting-shutdown

Button P1: Increase room temperature

Button P6: Increase output level

Button P5: Decrease output level

Button P2: Decrease room temperature

Button P4: Jolly

chrono functions from the menu 01-01.

battery tray

lever

AQUAPLUS 23