Publicité
Les langues disponibles
Les langues disponibles
2.5 Turbulator and baffle position check
Before lighting the stove make sure the brazier is in the correct position, i.e. fitted in the special slots. Also make sure
the turbulator shaker device is resting in a lower position. An incorrect position of the brazier and/or turbulators can
result in malfunctioning and excessive blackening of the glass.
At every stove lighting check the correct position of the brazier and turbulator shaker device.
2.6-Electrical connection
Connect one end of the power cable to the rear socket of the stove, and the other to the wall socket.
The voltage supplied by the system must match that specified on the stove dataplate and in the technical data section
of this manual.
Plug the device power cord must be connected only AFTER the end of the installation and assembly of the device
and must remain accessible.
During stove idle periods it is advisable to remove the power cable.
Make sure the electrical system is equipped with an earth and differential switch in accordance with the current
Regulations.
The power cable must never touch the stove exhaust pipe.
2.7-Wiring diagram
42
AQUAPLUS 23
Publicité
