Metabo HPT RP3608DA Instructions De Sécurité Et Mode D'emploi page 22

English
Safeguard Function
Overload Protection
Temperature Protection
ABOUT REMAINING BATTERY
INDICATOR
1. Battery
You can check the battery's remaining capacity by
pressing the remaining battery indicator switch to
light the indicator lamp. (Fig. 34, Table 7)
The indicator will shut off approximately 3 seconds
after the remaining battery indicator switch is
pressed.
It is best to use the remaining battery indicator as
a guide since there are slight diff erences such as
ambient temperature and the condition of the battery.
Also, the remaining battery indicator may vary from
those equipped to a tool or charger.
Remaining battery
indicator lamp
Display panel
Table 7
State of lamp Battery Remaining Power
Lights ;
The battery remaining power is
over 75%.
Lights ;
The battery remaining power is
50%–75%.
22
LED Light Display
On 0.1 second/off 0.1 second
On 0.5 second/off 0.5 second
Remaining battery
indicator switch
Fig. 34
Table 6
Remove the cause of the overloading.
Allow the tool and battery to thoroughly
cool.
The Table 8 shows the state of remaining battery
indicator lamp and the battery remaining power.
NOTE
Do not give a strong shock to the display panel
or break it. It may lead to a trouble.
2. Cleaner
Install batteries and press the battery switch of
the remaining battery indicator lamp to check
the displays for each battery. (Fig. 35)
The lamps will only light while the battery
switch of the remaining battery indicator lamp
is pressed.
The numbers 1 and 2 of the remaining battery
indicator lamp represent the numbered slots in
which the batteries are installed. (Fig. 35, 36)
Corrective Action
Lights ;
The battery remaining power is
25%–50%.
Lights ;
The battery remaining power is
less than 25%.
Blinks ;
The battery remaining power
is nearly empty. Recharge the
battery soonest possible
Blinks ;
Output suspended due to high
temperature. Remove the battery
from the tool and allow it to fully
cool down.
Blinks ;
Output suspended due to failure
or malfunction. The problem may
be the battery so please contact
your dealer.