Publicité
Les langues disponibles
Les langues disponibles
5.
Removing the battery (Fig. 10)
When removing the battery from the unit, press
the latches on both sides and slide the battery
upwards to pull it out.
Push
Latch
6.
Switch operation (Fig. 11)
During operation, suction power will change
each time you press the mode change-over
switch.
Mode display
lamp
Mode change-
over switch
Pressing the mode change-over switch switches
power as shown in Table 5.
Table 5
Display lamp
sequence
Air volume
57 (1.6)
cfm (m
/min)
3
Vacuum
degree
0.6 (42)
psi (hPa)
NOTE
When you switch ON the unit after switching it
OFF, the mode change-over switch will revert
to its state prior to being switched OFF.
The unit will revert to mode [2] when set at [3].
Pull out
Battery
Fig. 10
Fig. 11
85 (2.4)
124 (3.5)
1.2 (80)
2.9 (201)
HOW TO USE
CAUTION
Do not use the head top as a footstool or do
not sit on it. Otherwise the appliance begins
to move suddenly, causing an injury.
NOTE
Handle the hose with care. Do not bend the
hose by force, or do not trample it, or do not
pull it to move the cleaner. Moreover, do not put
away the hose as it is bent. Otherwise troubles
such as its deformation may be caused.
1.
Connecting the hose (Fig. 12)
Press the attached hose into the suction
opening of the tank until it clicks and connect
it. When removing the hose, pull out the
hose while pushing the button of the suction
opening.
Push
Suction opening
Button
2.
Attaching the plastic bag (Can be used
without a plastic bag)
WARNING
Be sure to turn off the vacuum switch and
remove the battery.
(1)
Detach two clamps, pull up the head by the
handle and remove it from the tank. (Fig. 13)
Remove the fi lter and the fi lter cage inside the
tank.
Handle
Cloth fi lter
Tank
English
Pull out
Push
Hose id 1-1/2" × 4.9 ft
(id 38 mm × 1.5 m long)
Fig. 12
Head
Filter cage
Clamp
Fig. 13
15
Publicité
