Publicité
Les langues disponibles
Les langues disponibles
7.
Dump dusts
WARNING
Be sure to turn off the vacuum switch and
disconnect the battery.
CAUTION
○
Do not impact the tank, the fi lter, or the head.
Otherwise they will be deformed or damaged.
○
Although it is based on the amount of suction
of dusts and liquids, dump dusts and liquids
in the tank at least once a day and keep the
appliance, the fi lter, etc. clean. Otherwise
suction power fall, motor failure, bad smell or
rusting may be caused.
○
Do not hold the clamps when you dump dusts
in the tank. Otherwise the clamps may be
damaged.
NOTE
Do not tilt the tank with accessories (Pipe,
Master nozzle, etc.) inserted in the base or in
the tank. Otherwise any part may be damaged.
WARNING
Before removing the head, if the appliance
is pushed on its side while the tank contains
liquid, the liquid will get inside the motor or
switch region, causing an electric shock or
motor failure.
Use a dust mask and safety glasses to protect
from rising dust.
(1)
Detach two clamps, pull up the head by the
handle and remove it from the tank. (Fig. 13)
Remove the fi lter and the fi lter cage inside the
tank.
(2)
Lightly striking the inner side of the cloth fi lter
several times, remove dusts attached to the
cloth fi lter.
(3) Tilt the tank and dump dusts. (Fig. 24)
(4)
Attach the cloth fi lter, the fi lter cage, the head,
and the clamp in the initial positions.
Tank
Fig. 24
<When using the plastic bag>
Drop the dust which has collected outside the
fi lter into the plastic bag, and after removing the
fi lter and fi lter cage, remove the plastic bag with
the dust from the tank and dispose the bag.
NOTE
○
When removing from the tank the plastic bag
containing the dust, try to remove the bag
without catching it on the protrusion inside the
tank.
○
Do not allow too much dust to accumulate in
the plastic bag.
8.
Transportation and storage
(1) How to use the handle (Fig. 25)
When carrying or moving the appliance, hold
the handle of the head part. When you do not
use the handle, put it in the head part.
(2) Fixation and release of the caster (Fig. 26)
By lowering the lever of the caster with the
brake, the rotation of the wheel is fi xed. When
releasing the fi xed wheel, raise the lever. When
moving with the appliance on a vehicle, fi x the
caster to retain the appliance. However, when
you move the appliance, check that the caster
is released, or the caster will be damaged.
Release
Tank
English
Handle
Head
Fig. 25
Fix
Lever
Caster
Fig. 26
19
Publicité
