Bosch TASSIMO TAS 47UC Serire Mode D'emploi page 19

en
Troubleshooting
The following table provides solutions for problems and glitches that may arise as you
use your TASSIMO machine. If you do not ind a solution for your speciic problem or the
problem persists after troubleshooting, please contact TASSIMO Customer Service at
1-877-TDISCS1 (1-877-834-7271).
Note:
i
If the piercing unit or the Service T DISC are lost, they may be purchased from TASSIMO
or Bosch Customer Service Department at 1-877-TDISCS1 (only in the USA) or on
www.tassimo.com.
Problem
Appliance not working;
no symbols light up.
Machine brews but no
drink dispensed.
Drink size smaller than
usual.
More steam than usual.
The appliance does not
recognize the inserted
T DISC and remains in
stand-by mode or the
Status LED lights up
F
red.
TAS47_UC.indb 17
Possible cause
There is no power
supply.
The water tank is not
correctly positioned.
The water tank was
removed during the
brewing process or there
is air in the system.
The loat in the water
tank is stuck.
Not enough water in the
water tank.
The appliance needs
descaling.
The appliance needs
descaling.
Appliance is not switched
on.
No T DISC inserted.
The barcode could not
be detected.
The brewing unit is not
properly closed.
Solution
Check that the appliance is prop-
erly plugged into the power supply.
Make sure that the water tank is
positioned correctly.
Start a cleaning cycle with the
Service T DISC.
Clean the water tank and ensure
the loat can move.
Fill the water tank after the drink
has inished dispensing and press
the Start / Stop button to inish the
drink.
Descale the appliance (for details
see "Descaling").
Descale the appliance (for details
see "Descaling").
Make sure the appliance is
switched on before inserting a
T DISC.
Check if T DISC has been
inserted.
Clean the T DISC barcode reading
window and try again or smooth
out the barcode on the T DISC
with your thumb.
Use another T DISC.
If problems persist, contact the
TASSIMO Customer Service.
Clean the brewing unit thoroughly,
especially in the area of the clamp.
17
05/2012
04.05.2012 12:36:20