Bosch TASSIMO TAS 47UC Serire Mode D'emploi page 16

14
3.
5.
min.
17 oz. /
500 ml
7.
5 sec.
!
IMPORTANT
The descaling program runs for
approximately 20 minutes.
Bosch Home Appliances
TAS47_UC.indb 14
4.
6.
20 min.
3. Fill the water tank (5) up to the
descaling mark "0,5 l" (5b) and add the
descaling agent in accordance with the
manufacturer's instructions.
Note:
i
If you have hard water, increase the
amount of descaling agent.
4. Replace the water tank by tilting it
slightly and returning it to its original
position until it clicks into place.
5. Place a container with a capacity of
at least 17 oz. / 500 ml under the drink
outlet (4d).
6. Open the brewing unit (4) by lifting
the handle (4a) and then pushing the
brewing unit up. Place the Service
T DISC (6a) on the T DISC holder (4b)
with the barcode facing down. Make
sure that the l ap of the T DISC is
located in the slot in the front.
Close the brewing unit by i rst bringing
►
it down and then pushing the handle
i rmly into the machine until you hear an
audible click.
7. Press and hold the Start / Stop button
(2) for at least 5 seconds to start the
descaling program.
Release the Start / Stop button after
►
5 seconds; the machine will run the
descaling cycle automatically. This is
indicated by the Status LED
"Descale required" LED
Note:
i
The descaling solution is pumped through
the machine in intervals and then runs into
the container until the water tank is almost
empty. A small amount of liquid is always
left in the tank.
en
(3a) and
F
(3c) blinking.
'
04.05.2012 12:36:19