Warranty - Cristec CPS3OEM Série Manuel D'utilisation

Precautions regarding lightning
In areas highly exposed to lightning, it may be advisable to install a lightning arrestor upstream of
the charger to safeguard it against irreversible damage.
Precautions regarding overheating of the appliance
This appliance is designed to be mounted on a vertical wall or partition as indicated herein.
It is imperative that there be a gap of 150mm around the charger. The installer must see to it that the
temperature of the air at the input is lower than 65°C in extreme operating conditions.
Measures should also be taken to allow for the discharge of hot air on either side of the charger.
It's strictly forbidden to put any device on or against the charger.
The charger must not be installed near a source of heat; it should be installed in a well-ventilated
area. The charger's air inlets and outlets must not be obstructed.
Be careful hot surface: do not touch the charger during and after its operation (risk of burn).
Precautions regarding dust, seepage and falling water
The charger should be located so as to prevent penetration of damp, liquid, salt and dust, any of
which could cause irreparable damage to the equipment and be potentially hazardous for the user.
The appliance should be installed in a dry and well-ventilated place.
Precautions regarding inflammable materials
The charger should not be used near inflammable materials, liquids or gases.
The batteries can emit explosive gases: please follow the manufacturer's instructions carefully when
installing them.
Nearby the batteries: ventilate the place, do not smoke, do not use any high flame.
Use fuses as defined in this manual.
Other precautions
Never attempt to drill a hole in or to machine the charger's case: this may damage components or
cause metal chips or filings to fall on the charger's board.
Do not do anything that is not explicitly stated in this manual.
1.2.
W
ARRANTY
The manufacturer disclaims the warranty and CRISTEC waives any liability whatsoever if the installation
rules and instructions for use are not observed.
The warranty is valid for 36 months. It covers parts and labour for equipment returned to the Quimper plant.
Only original parts recognized as being defective will be replaced under the warranty.
CPS3OEM-1M-2M-DEC 17