DITEC REX1 Manuel D'installation Et D'entretien page 15

OPERATING INSTRUCTION FOR REX SLIDING DOORS AUTOMATION
RELEASE INSTRUCTION
In case of maintenance, malfunction, or emergency, lower re-
lease lever and manually move the wings to open position.
LOCK INSTRUCTION
To relock, return release lever to its previous position.
Attention: Perform the lock and release operations with the
motor stopped.
STOP position prevents the batteries from engaging in case of
emergency.
Note: For correct door operation and regular battery recharging,
it is essential that the automatic system be always powered with
batteries connected (also during the night).
GENERAL SAFETY PRECAUTIONS
The following precautions are an integral and essential part
of the product and must be supplied to the user.
Read them carefully as they contain important indications for
the safe installation, use and maintenace.
These instruction must be kept and forwarded to all possible
future user of the system.
This product must be used only for that which it has been ex-
pressely designed.
Any other use is to be considered improper and therefore dan-
gerous.
The manufacturer cannot be held responsible for possible da-
mage caused by improper, erroneous or unresonable use.
Avoid operating in the proximity of the hinges or moving mecha-
nical parts.
Do not enter the field of action of the motorised door or gate
while in motion.
Do not obstruct the motion of the motorised door or gate as this
may cause a situation of danger.
Do not lean against or hang on to the barrier when it is moving.
Do not allow children to play or stay within the field of action of
the motorised door or gate.
Keep remote control or any other control devices out of the reach
of children, in order to avoid possible involuntary activation of the
motorised door or gate. In case of breack down or malfunctioning
of the product, disconnect from mains, do not attempt to repair
or intervene directly and contact only qualified personnel.
Failure to comply with the above may create a situation of
danger.
All cleaning, maintenance or repair work must be carried out by
qualified personnel.
In order to guarantee that the system works efficiently and
correctly it is indispensable to comply with the manufacturer's
indications thus having the periodic maintenance of the motori-
sed door or gate carried out by qualified personnel.
In particular regular checks are recommended in order to verify
that the safety devices are operating correctly. All installation,
maintenance and repair work must be documented and made
available to the user.
DITEC S.p.A.
Via Mons. Banfi, 3
21042 Caronno Pertusella (VA) - ITALY
Tel. +39 02 963911 - Fax +39 02 9650314
www.ditec.it - ditec@ditecva.com
SELECTORS FUNCTIONS
DOOR CLOSED
TOTAL BI-DIRECTIONAL OPENING
TOTAL UNI-DIRECTIONAL OPENING
STOP
DOOR OPEN
PARTIAL OPENING
ON
OFF
Installer:
GB
Com96 ComH-K
6
2
1
5
4
3