Local Time Setting - FTE UNIVERS U7000 Manuel De L'utilisateur

OSD 71
OSD 72
OSD 73
SYSTEM SETUP
control the date on which you want to activate the alarm
service.
- On time: Introduce using the numerical keys on the remote
control the time on which you want to activate the alarm
service.
- Length: Settle the length of time you want the receiver to keep
one channel. Once it is finished, the receiver will be settled
in StandBy. If you do not want the receiver to be settled on
Stand-By, you have to configure the length to 00:00.
Note: If the date/ start time is prior to the current date/hour,
a warning message will be shown and you have to change the
date/start time.
5. Message option: If you select this option, the following image
fields will be active in order that you can configure them (OSD
72).
- Start message: Use the keys [
want to appear on the screen
- Start date: Introduce using the numerical keys on the remote
control the date on which you want to activate the service.
- On time: Introduce using the numerical keys on the remote
control the time on which you want to activate the service.
Automatically, a message will be shown although the receiver
is ON or in Standby.
Note: If the date/ start time is prior to the current date/hour,
a warning message will be shown and you have to change the
date/start time.
6. Auto OTA Config.:If you choose this option, the following
fields of the image will appear in order to be configured (OSD
73).
-Starting date: Insert, using the numerical keys of the remote,
the date when you want the software of the receiver to be
updated.
-On time: Insert, using the numerical keys of the remote,
the time when you want the software of the receiver to be
updated.
7. Press [Exit] to leave the "Timer" menu.
Note: If the receiver is in stand-by, and Low Power Consumption
mode is active, the receiver will switch on 1 minute before the
programmed event.
* This function will only be available in models with PVR
ready functionability

5.3.2. LOCAL TIME SETTING

When you select "Local Time Setting" and press [OK] then you
will see a window like the one beside (OSD 74):
1. GMT Usage: This item is used to set the time by using the
time signal from the satellite. Press [
setting.
2. The "GMT Offset" item is only available when "GMT Usage"
is set to "On". Press [
PAG. 33
] to select the text you
] to change the
] to set the "GMT Offset" value.