Satellite List; Tp List - FTE UNIVERS U7000 Manuel De L'utilisateur

OSD 55
OSD 56
OSD 57
OSD 58
OSD 59
INSTALLATION
will search the selected TP. In case you select "On", the NIT
(Network Identification) will be identified and the receiver will
automatically search all the TP of this network.
6. Press [OK] to start scanning.
7. On the "TP Scan" item, press [Exit] to cancel the scanning
and saving the found channels.

4.4. SATELLITE LIST

When you enter the "Satellite List" menu you can see a window
like the one beside (OSD 55):
1. Move through the satellite list using [
2. Press [Red] button to enter edit satellite menu (OSD 56).
You can edit the satellite's name and its longitude. Once you
have edited the satellite, select "Save" option and confirm with
[OK]. If you prefer to exit without saving the changes select
"Exit" and press [OK].
3. Press [Green] button to open the "Add satellite" window. You
can edit the satellite's name and its longitude. Once you have
edited the satellite, select "Save" option and confirm with [OK].
If you prefer to exit without saving the changes select "Exit" and
press [OK].
4. After pressing [Yellow] button you will be asked "Are you
sure to delete?" (OSD 57). Select "Yes" to delete the marked
satellite. Select "No" to cancel the operation.

4.5. TP LIST

When you open the "TP List" menu you will see a window like
the one beside (OSD 58).
1. Press [ ] to change the marked satellite. Press [
] to change the marked TP.
2. Press [Red] button to open the "Edit TP" menu (OSD 59).
Here you can edit the Transponder's data like frequency, polarity
and Symbol Rate. If any of the TP of the list have tuned and
stored channels into the receiver, the following three options
"Frequency", "Symbol Rate" and "Polarity" will not be able to
be edited.
It means that the parameters cannot be modified by error
neither loosing the stored channels when any value of the data
base is changed.
In case of any value, for example the Symbol Rate of a TP,
has been modified by the provider and the receiver has these
channels tuned, the TP must be deleted (it will delete all the
channels of this TP), create it again with the correct data. In
this window, the search of the channels of the TP can be done
selecting the "Search" option and pressing [OK].
3. Press [Green] button to open the "Add TP" menu (OSD
60). Here you can add a new TP and setup its parameters like
frequency, polarity and Symbol Rate. In this window, the search
PAG. 29
].